Home 
WLC-Cameras NemoKit
NemoKit CAPABILITY
WLC-Cameras NemoKit
NemoKit
NemoKit system supports the full line of Nemotek’s wafer level cameras.
The current demonstration system uses the USB 2 interface to transport raw digital video data from the sensor to the host PC. A software application is provided with the demonstration system to enable the user to display the data from the sensor on the host computer, and to change some basic settings of the sensor for evaluation purposes.
NemoKit contains a removable daughter board for each Wafer Level Camera.
Hardware Requirements
- Pentium III 450 MHz or higher
- 128MB RAM
- USB 2.0 Host controller
Software Requirements
- Minimum Windows XP or later version
NemoKit System Contents
- Daughter board with a WLC camera
- Mother board
- Nemotek’s case
- USB 2.0 cable
- Software CD
- Demo user manual
| This release | |||
|---|---|---|---|
| Maximum Video Resolution | Up to 5MP | ||
| Buffer Memory Data Bus Width | 16bit | ||
| Buffer Memory Operating Freque ncy |
80MHz | ||
| Buffer Memory Size Total | 32MBytes = 8MWord x 2Logical Bank | ||
| Maximum Number of Frames to S tore (Logical Bank) |
2 | ||
| Maximum Data Transfer Rate | 48MBytes/Sec | ||
| Supported Video Format | YUV 422 , Bayer (8/10/12/14), RGB565 | ||
| Supported Operating System | Microsoft Windows XP, Windows Vista | ||
| Power Requirement | USB Bus Power | ||
Download datasheet 